Description

Waterjet Cutter Hydraulic Seal Cartridge Assembly 05130091

Waterjet Cutter Hydraulic Seal Cartridge Assembly 05130091 is applied for SL-VI 50HP pump

How much do you know about water jet cutter precautions?

You may not know much about waterjet cutter , it is an industrial tool that is of great help to our industrial production. But we have a lot of things to pay attention to in the process of daily operation of waterjet cutter, do you understand? If you don’t know the operation of the water jet, you can follow the editor to get to know it well. I believe you will gain a lot.

Precautions for waterjet operation:

1.After the waterjet cutter abrasive nozzle has been used for a period of time, rotating it at an angle and continuing to use it can greatly improve the life of the abrasive

2.Please do not try to buy cheap parts that are not provided by the manufacturer. Not only the quality of the parts cannot be obtained, but it may also harm your equipment and cause greater losses. At the same time, you will lose the manufacturer’s warranty for your equipment, which is really not worth the candle.

3.The user can backup the parameters in the waterjet cutter CNC system so that they can be restored when needed.

4.When the user cannot determine the cause of the fault after the fault occurs, please observe the fault phenomenon in detail and report it to the customer service personnel of water jet cutter near me. Under the guidance of the customer service staff, analyze and determine the cause of the fault and eliminate it.

5.Do you know how to quickly judge which end of the high and low pressure check valve is not well sealed? In fact, we can touch the high and low pressure parts at both ends with both hands. The high temperature end must not have a good sealing effect.

6.In order to prevent water leakage when the steel pipe is connected, the thread of the steel pipe head must be higher than three teeth of the screw washer.

7.When a fault occurs and it is impossible to judge whether the problem is in the water circuit or the oil circuit, the water circuit can be partially removed, and then the oil pump and high-pressure water switch are turned on to observe whether the cylinder piston reversing is normal. To determine whether the problem is a water failure or an oil failurefor water jet cutter.

8.After starting up normally, keep pressing the high-pressure water button and keep it on. At this time, the device will stop changing direction and display high pressure. If the oil pressure gauge can rise to the actual pressure at this time, it can be confirmed that the relief valve is normal. of.

9.When the waterjet cutter is turned on normally but the equipment does not change direction, we can remove the two electric plugs on the reversing valve. Then push the spool inside the rubber cover at both ends of the reversing valve alternately by hand. If the equipment can be changed again , it can be confirmed that the reversing valve is normal.

10.When thewaterjet cutter intensifier is turned on for the first time after maintenance, in order to protect the equipment, the pressure needs to be lowered first, and then slowly increased to the operating pressure.